-
Bolex EBM 7-pin Right-Angle Power Cable, Unregulated D-Tap, ~45cm (18″)
The maximum for Bolex electronics is 15V. This ~45cm (18″) cable use a right-angle 7-pin Tuchel connector from Amphenol to connect to an EBM. The cable exits directly toward the rear of the EBM as shown in the photo with the EBM shell.You will need a switch on your power source to turn the EBM…
-
Bolex Base plate for Bolex H16 or H8 Reflex and Non Reflex cameras
It does show wear check pics to get an idea.
-
Original BOLEX Turret cap for Vintage 16mm H16 Movie Camera
Original BOLEX Turret cap for Vintage 16mm H16 Movie Camera No International shipping
-
NOS Bolex 400′ FILM MAGAZINE For Bolex 16mm Reflex Rx 5 EBM SBM Movie Camera
This magazine is made for the Bolex 16mm. Available is a newBolex 400 Foot Film Magazine.
-
Bolex EL Right-Angle 4-pin Power Cable, 12V 2.1mm DC barrel plug, ~0.5m (20″)
This ~0.5m power cable allows you to connect a Bolex EL directly to a 12V battery or a regulated battery plate with a 12V 2.1mm DC port (center positive). This cable uses a 7-pin Amphenol-Tuchel right-angle connector and a 5.5mm x 2.1mm barrel plug made by MPD.
-
Bolex ESM 3-pin Power Cable, Unregulated D-Tap, ~40cm (16″)
The maximum for Bolex electronics is 15V. This ~40cm (16″) power cable uses a 5-pin Tuchel connector from Amphenol that is backwards compatible with the 3-pin male socket on the ESM. Use the ESM’s power button on the front to turn the motor on/off (unless your ESM has been modified).
-
Factory Bolex Leather LENS CASE For Yvar 100mm C-Mount Lens
Yvar 100mm. It was quality made in Switzerland by Bolex. Available is aBolex Lens Case. It will fit the following C-Mount lens.
